Герметики и заполнители швов \ Emülderz 2010 - Битумен резины на основе совместного наполнителя

Ürün Teknik Dökümanları

Tanımı
It is an elastomeric, hot-applied, bitumen-rubber based joint filler used at horizontal and vertical joints.
 
Usage Areas
• It is used for waterproofing, filling, repair and adherence in:
• Dilatations, joints,
• Intersections of cement coatings with wide surfaces,
• Dams, channels and ducts,
• And other locations where any dilatation may occur.
• It is used for installing reflective road buttons onto asphalt.
Advantages
• It is very elastic. It maintains its elasticity between -20°C and +80°C.
• It is heated up either in a special double walled boiler or directly on a furnace.
• It is suitable to contact with potable water. (Hacettepe University Report No.: 2003-381)
Surface Preparation
• The surface to be treated must be clean and dry.
• The joints must be cleaned with a wire brush, spiral engine or sandblasting.
• If possible joint spacing must be treated with compressed air.
 
Application
• To provide excellent adherence, and improve durability, non-metallic surfaces can be undercoated with Emilkote®, and metallic surfaces can be undercoated with Emülzer® C.
• Emülderz® is heated up to approximately 160-180°C, mixed thoroughly and poured into joint gaps.
• The surface treated will be ready to use after approximately 1 hour.
• If the product is overheated, that is up to temperatures over 160-180°C or if it is heated up and cooled back for a few times it will be spoiled and cannot be recovered.
 
Consumption
1,17 kg/dm3
Example: For joints with 1 meters lenght 5 cm width and 3 cm depth 1 m x 0,05 m x 0,03 m x 1,17 kg/dm 3 x 1000 = 1,755 kg of product used.
 
Packaging
17 kg Metallic case - 45 Pieces / Pallet
Bulk in easy-to-separate cardboard box
 

Ürün Teknik Dökümanları