Em-Poxy 310 Fixing and Adhesive Mortar | Герметики и заполнители швов

• It is used; for mounting expansion tapes,
• For filling tie rod holes,
• For repairing columns, curtains and girders,
• As a mounting, filling and bevelling mortar for waterproofing joints,
• For repairing and waterproofing concrete cracks,
• For repairing all types of structural concrete,
• For mounting and adhering all types of metal elements onto concrete or steel elements.

Advantages

• Highly resistant to corrosion, abrasion and chemicals.
• Resistant to vibration.
• Does not shrink.
• Waterproof and gas-proof.
• Due to fast curing, allows loading in a very short period of time.
• Has high adherence.
• Non-solvent.
• Easy-to-mix and easy-to-apply.
• Has perfect adhesion to concrete, steel and many other building materials.
• Thixotropic; does not creep in horizontal and overhead applications.

Application

• The dosage of the components are designed according to application requirements.
• The hardener is poured into the epoxy and mixed to a homogenous consistency and gray colour; to prevent air bubbles a low speed mixer must be used.
• Pot life must be considered in the preparation of the material and only required amount of it must be mixed. Because it is non-solvent, it cannot be thinned with a thinner.
• During application the air temperature must be +5°C minimum.

Surface Preparation

The concrete should be firm and strong. Holes must be cleared with pressured air, leaving behind no grease, dust, plastic particles or water. Cement based surfaces must be cleared from all dirt and dust prior to application. Metal surfaces must also be cleared from rust and dirt. The material must be mixed to a homogenous consistency with a low speed mixer for at least 2-3 minutes; it should not at all be mixed manually or with a trowel. It must be applied with a trowel or spatula. During application surface, ambient and material temperatures must be between +5°C and +30°C.

Cleaning the Equipment

The equipment used should be cleaned with a detergent and warm water if possible, otherwise with a cellulosic thinner.

Consumption

1,6 kg/dm3
Approximately 2 kg for 1 meter of expansion tape.

Packaging

Epoxy resin + Hardener = Net 5 kg as a set
60 Sets / Pallet

Teknik Bülten

Ürün Teknik Dökümanları

Teknik Bülten